Moturo Starter Motor for Bashan BS250S-11 ATV Quad

Moturo Starter for Bashan BS250S-11 ATV Quad

The Moturo starter for your Bashan BS250S-11 quad — the typical wear part in the starting system that slips or turns too slowly after extended use. 11 teeth on the drive pinion, factory bolt pattern matching the original version, ready for installation.

The starter is mounted on the engine housing and cranks the engine when the start button is pressed. The 11 teeth on the drive pinion engage with the starter ring gear on the flywheel. The BS250S-11 platform is a single-cylinder engine with 250 cc displacement and 10.5 kW engine output; the starter follows the factory bolt pattern and plug geometry of the original components. The power supply and mounting bolts are in the original positions, so the replacement process runs without any modifications to the wiring harness or brackets.

Replacement takes about an hour using a hex key set, socket wrench set, and torque wrench.

Starter for the Bashan quad, made by Moturo.

Performance · Material · Specifications

• 11 teeth on the drive pinion
• 250 cc displacement, 10.5 kW engine output for the Bashan platform
• Factory bolt pattern and plug geometry of the original components

Important notes – please read

Replacement/wear part that does not require registration; the replacement does not need to be officially recorded. Model assignment: Bashan BS250S-11; other platforms are not listed.

Tools & time required

• Hex key set in common sizes
• Socket wrench set for the mounting nuts
• Torque wrench
• About an hour for an experienced mechanic

Scope of delivery

1 × Starter (ready for installation). Not included: mounting screws, gasket, tools.

Frequently asked questions

Does the starter fit other Bashan models with 250 cc?
Only the BS250S-11 is listed. For other platforms, compare the bolt pattern, number of teeth, and plug geometry with the photo on the product page.

How many teeth does the drive pinion have?
11 teeth — matching the starter ring gear of the BS250S-11.

Does the component need to be registered?
No. This replacement/wear part does not require registration; what is important are the correct dimensions, design, and proper installation.