Moturo Ball Bearing 42mm 25mm-9mm 6905RS

Moturo Deep Groove Ball Bearing 6905-2RS 42×25×9 mm for ATV, Quad and Scooter

The Moturo 6905-2RS deep groove ball bearing for ATVs, quads and scooters — the bearing you replace as a matter of routine at the end of the season. 42 mm outer, 25 mm inner, 9 mm thick, rubber-sealed on both sides, ready for installation.

The bearing runs in wheel hubs, variomatic shafts and swingarm bearings of pit bikes, ATVs, quads and scooters. Outer diameter 42 mm, inner diameter 25 mm, thickness 9 mm. Rubber seals on both sides keep dust and splash water out, while the inside of the bearing runs in a lubricated metal cage. Material according to product data is metal with rubber seals.

Replacement takes about half an hour with a bearing puller, soft-face hammer and suitable drift punch — when driving in, only apply pressure to the outer ring, do not strike the inner ring.

Bearing for ATV, quad and scooter, made by Moturo.

Performance · Material · Specs

• Outer diameter 42 mm, inner diameter 25 mm, thickness 9 mm
• Bearing type 6905, design 2RS, rubber-sealed on both sides
• Universal size for 25 mm shaft and 42 mm bearing seat

Important notes – please read

Component for racing and off-road use. No ABE/StVZO approval. Not for public road use. Compare dimensions with the installed bearing before ordering.

Tools & Time Required

• Bearing puller or soft-face hammer with suitable drift punch
• Torque wrench if the shaft has a lock nut
• About half an hour for an experienced mechanic

Scope of delivery

1 × deep groove ball bearing 42×25×9 mm, rubber-sealed on both sides. Not included: tools, cleaning agents.

Frequently asked questions

Does the bearing fit every 25 mm shaft?
Yes, provided the bearing seat in the housing measures 42 mm and the shaft has an outer diameter of 25 mm.

Do I need special tools for the replacement?
A bearing puller and a soft-face hammer with a drift punch are sufficient. When driving in, only apply pressure to the outer ring, do not strike the inner ring.

Is the bearing approved for road use?
No, the component is intended only for racing and off-road use and does not have road homologation.