Moturo carburetor repair kit for Suzuki LTF400 03-07

Moturo Carburetor Repair Kit for Suzuki LTF400 Eiger 03-07

The Moturo carburetor repair kit for your Suzuki LTF400 Eiger 03-07 — the go-to set for your carburetor after long periods of inactivity or if you have a rough idle. Includes float needle valve and jets, ready for installation.

This kit replaces the wear parts in the carburetor of the LTF 400 F Eiger (model years 2003 to 2007, 376 cc). It contains a float needle valve, jets, jet needle, O-rings, and other small parts to address typical causes of wear after sitting idle. Component quality is at least equivalent to the original, and the bore sizes correspond to the LTF400 carburetor specifications.

Before installation, remove the carburetor, drain the float chamber, and remove all old gaskets completely. Installation takes about an hour using screwdrivers, an Allen key set, and a tray for the small carburetor parts. Tighten jets carefully.

Carburetor repair kit for Suzuki LTF400 Eiger, manufactured by Moturo.

Performance · Material · Facts

• 376 cc displacement, suitable for the LTF 400 F Eiger carburetor family
• Float needle valve, jets, and jet needle included in the set
• Component quality at least equal to original standards

Important Notes – Please Read

Original equipment replacement type, no separate ABE (general operating permit) required. Completely disassemble the carburetor before installation and remove all old gaskets. Compare the components with the image on the product page before installation.

Tools & Time Required

• Screwdriver set (Phillips and flat-head)
• Allen key set in common sizes
• Tray for small carburetor parts
• About one hour for an experienced mechanic

Scope of Delivery

1 × Carburetor repair kit including float needle valve, jets, jet needle, O-rings, and other small parts. Not included: carburetor housing, tools, cleaning fluid.

Frequently Asked Questions

Does this kit also fit the LTF 400 from 2008 onwards?
No, there was a change in the carburetor revision.

Are the jets pre-jetted?
No, they correspond to the standard factory sizes for the LTF 400 F.

Do I need TÜV registration?
No. Original equipment replacement type, no ABE required.