Moturo Adapter 22mm alu for intake manifold 70-125cc dirt bike

Moturo Intake Manifold Adapter 22mm for Dirt Bike 70-125cc

The Moturo 22mm aluminum intake manifold adapter for 70 to 125cc dirt bikes — a spacer between the engine and intake manifold that rotates the intake tract into the desired position. Universal part, ready for installation.

The adapter sits between the engine and intake manifold, allowing for a modified alignment of the intake tract — useful if your carburetor or air filter would otherwise collide in a custom setup. It bolts onto the engine casing, and the intake manifold is mounted directly onto the adapter. Aluminum, 22 mm inner diameter, universal design for 70 to 125 cc engines.

Replacement takes about half an hour with a hex key set, a new flat gasket, and a torque wrench. Clean the contact surface and check for flatness before tightening, otherwise the engine will draw false air.

Intake manifold adapter for your dirt bike, made by Moturo.

Performance · Material · Specs

• Aluminum, 22 mm inner diameter
• Spacer between engine casing and intake manifold
• Changes the alignment of the intake tract
• Universal design for 70 to 125 cc engines

Important notes – please read

Component for race and off-road use. No ABE/StVZO approval. Not for use in public road traffic. Universal part: Please compare the bolt pattern, hole spacing, and connection dimensions with your own engine before ordering.

Tools & time required

• Hex key set in common sizes
• New flat gasket
• Torque wrench
• Approximately half an hour for an experienced mechanic

Scope of delivery

1 × Intake manifold adapter 22 mm made of aluminum. Not included: flat gasket, screws, intake manifold, carburetor, tools.

Frequently Asked Questions

Does the adapter fit every dirt bike engine from 70 to 125 cc?
Not necessarily. Please compare the bolt pattern and hole spacing on the engine with the photo on the product page.

Do I need my own gasket?
Yes, a new flat gasket between the engine and adapter is recommended; otherwise, the engine will draw false air.

Which carburetor can I connect?
The adapter holds the intake manifold; the connection dimension to the carburetor is determined by the manifold, not the adapter.