Moturo tire inner tube 4.10/3.50-4 for pocket quad

Moturo Inner Tube 4.10/3.50-4 for Pocket Quad

The Moturo inner tube 4.10/3.50-4 for your pocket quad — the most common wear part on small quad tires, regularly needed after a puncture or a slow loss of pressure at the rim or valve base. Universal size 4.10/3.50-4, ready for installation.

The tube replaces the worn or burst original tube of your pocket quad. The 4.10/3.50-4 size covers both common tire widths and fits practically any 4-inch rim on typical pocket quads.

Before installation, check the rim flange and the inside of the tire for burrs and residual dust, otherwise the new tube will rub through immediately. Slightly pre-inflate the tube, insert it, and guide the valve cleanly through the rim.

Replacement takes about half an hour with tire levers, a pump, and a valve core tool.

Inner tube for your pocket quad, made by Moturo.

Performance · Material · Facts

• Size 4.10/3.50-4, covers both common tire widths
• Fits almost all pocket quads with 4-inch rims
• Most common tire size in the pocket quad class
• Universal item — not a model-specific component

Important notes – please read

Non-registered replacement/wear part; the replacement does not need to be registered. Non-registered replacement/wear part; the replacement does not need to be registered. Other tire sizes such as 4.10-6 or 145/70-6 require a different tube.

Tools & Time Required

• Tire levers (at least two)
• Air pump or compressor
• Valve core tool
• About half an hour for an experienced mechanic

Scope of delivery

1 × Inner tube 4.10/3.50-4. Not included: Rims, tires, tools, tire paste.

Frequently asked questions

Does the tube also fit a 4.10-6 tire?
No, that is a different size. 4.10/3.50-4 only fits rims with a 4-inch diameter.

What kind of valve does the tube have?
Compare the valve position and design with the product image before ordering — pocket quads use different valve types depending on the manufacturer.

Does the part need to be registered?
No. This replacement/wear part does not need to be registered; proper dimensions, design, and correct installation are what matter.