Moturo rear axle swing arm black for Bashan BS250S-11

Moturo rear swingarm in black for Bashan BS250S-11

The Moturo rear swingarm in black for your Bashan BS250S-11 quad — the load-bearing connection between the frame and the rear wheel, supported on both sides by needle bearings. Complete with swingarm bolt and two cover caps, ready for installation.

The swingarm guides the rear wheel on your Bashan BS250S-11 quad and transmits the drive forces between the frame and the axle. Both needle bearings are factory-pressed into the swingarm, and the matching swingarm bolt and two cover caps are included. The frame mounts correspond to the original design of the BS250S-11; tightening torques follow the quad's workshop manual.

Before installation, lightly grease the bearing surfaces and insert the swingarm bolt through the center. Replacement takes about an hour with a socket wrench set, rubber mallet, and torque wrench.

Swingarm for the BS250S-11, made by Moturo.

Performance · Material · Facts

• Both needle bearings factory-pressed into the swingarm
• Swingarm bolt and two cover caps included
• Frame mounts in OE design for the BS250S-11
• Finished in black

Important notes – please read

Original spare part design, no separate ABE (general operating permit) required. Compare dimensions, swingarm bolt, and mounts with your BS250S-11 before installation.

Tools & time required

• Socket wrench set in common sizes
• Rubber mallet for driving out the swingarm bolt
• Torque wrench
• About one hour for an experienced mechanic

Scope of delivery

1 × swingarm in black for BS250S-11, 2 × needle bearings (already pressed into the swingarm), 1 × swingarm bolt, 2 × cover caps. Not included: tools, grease.

Frequently asked questions

Are the needle bearings already pressed in?
Yes, both needle bearings are factory-pressed into the swingarm and ready for installation.

Does the swingarm fit other Bashan quads?
Compare the hole pattern, mounts, and swingarm bolt length with the product image before ordering.

Do I need a TÜV registration?
No. Original spare part design, no modification requiring registration.