Moturo rear axle swing arm silver for Bashan BS200S-7

Moturo rear axle swingarm silver for Bashan BS200S-7

The Moturo swingarm for the rear axle of your Bashan BS200S-7 ATV — the load-bearing component between the frame and the rear wheel, the most common replacement part after bearing damage. Two pre-installed needle bearings, ready for installation.

The swingarm guides the rear wheel and transfers forces from the drive and brake between the frame and the axle of your Bashan BS200S-7. The two needle bearings are already pre-installed in the swingarm eyes, and the hole pattern for the swingarm bolt and shock absorber mount corresponds to the original replacement part design. Tightening torques follow the BS200S-7 workshop manual.

Replacement takes about an hour with a hex key set, a socket wrench set for the axle nut, and a torque wrench. Tighten the swingarm bolt to the specified torque, and check chain alignment and lateral play after installation.

Swingarm for the BS200S-7 ATV, made by Moturo.

Performance · Material · Figures

• Two pre-installed needle bearings in the swingarm eyes
• Hole pattern for swingarm bolt and shock absorber mount in original replacement part design
• Tightening torques according to the BS200S-7 workshop manual
• Color: silver

Important notes – please read

Original replacement part design, no separate ABE (general operating permit) required. Compare dimensions, swingarm bolt diameter, and shock absorber mount with your ATV before ordering; different Bashan models are not approved.

Tools & time required

• Hex key set in standard sizes
• Socket wrench set for swingarm bolt and axle nut
• Torque wrench
• Approx. one hour for an experienced mechanic

Scope of delivery

1 × rear axle swingarm silver with two pre-installed needle bearings. Not included: swingarm bolt, axle nut, shock absorber, tools.

Frequently asked questions

Are the needle bearings already pressed in?
Yes, both needle bearings are pre-installed in the swingarm eyes at the factory.

Do I need a TÜV registration?
No. Original replacement part design, the replacement does not require registration.

Does the swingarm fit other Bashan models?
Only the BS200S-7 is approved. Compare the hole pattern and axle diameter of other models with the photo on the product page before ordering.