Moturo handlebar switch left type 3 -4 functions- for ATV quad

Moturo left handlebar switch Type 3 for ATV and quad

The Moturo left handlebar switch Type 3 for your ATV or quad — the switch to reach for first after a fall, water ingress, or stuck buttons. Four functions, ready for installation.

The switch is mounted on the left side of the handlebar and controls the starter, kill switch, low beam, and high beam. Connection is via a single plug with nine wires; the configuration follows the original switch wiring of your ATV or quad.

Replacement takes about half an hour with a hex key set, screwdriver, and a little patience when sorting the wires. Before plugging it in, check the polarity against the workshop manual or the old switch.

Left handlebar switch for your ATV and quad, made by Moturo.

Performance · Material · Facts

• Four functions: starter, kill switch, low beam, high beam
• Connection via single plug with nine wires
• Left handlebar side, universal design for ATVs and quads

Important notes – please read

Original spare part design, no separate ABE (general operating permit) required. Universal item — please compare plug shape, wire colors, and handlebar clamp with the original switch before ordering.

Tools & Time required

• Hex key set in standard sizes
• Screwdriver
• About half an hour for an experienced mechanic

Scope of delivery

1 × left handlebar switch Type 3 with four functions and nine-pin wiring harness. Not included: mating plug, cable ties, tools.

Frequently asked questions

Does the switch fit every ATV?
Universal design — please compare plug shape and wire assignment with the original switch before ordering.

Do I need a TÜV registration?
No. Original spare part design, no separate ABE required.

How do I know which wire goes where?
Compare the nine wire colors with the old switch or the workshop manual of your ATV or quad.