Moturo ignition coil with spark plug connector, complete, black for 150-250cc ATV Quad

Moturo ignition coil with spark plug connector for 150-250cc ATV/quad

The Moturo ignition coil set for ATVs, quads and scooters from 150 to 250 cc — the first component to check in the diagnostic process if there is no spark. Two-pin connection, approx. 37 cm ignition cable and angled spark plug connector, ready for installation.

The ignition coil converts the low-voltage pulse from the CDI into high voltage for the ignition spark. The two-pin connection fits common 150cc to 250cc single-cylinder engines in the ATV, quad and scooter sectors.

The ignition cable measures approx. 37 cm and is long enough for standard routing paths over the frame and cylinder head. The spark plug connector is angled at 90 degrees, allowing it to lie flat against the spark plug as intended by the factory for most quad engines.

Replacement takes about half an hour with a socket wrench and torque wrench.

Ignition coil set for ATV and quad, made by Moturo.

Performance · Material · Specs

• Two-pin connection
• Ignition cable with a length of approx. 37 cm
• Spark plug connector angled at 90 degrees
• Designed for common 150 to 250 cc single-cylinder engines

Important notes – please read

Replacement/wear part that does not require registration; no entry in vehicle documents is necessary. Before purchasing, please compare the connection type and cable length with the existing component.

Tools & Time required

• Socket wrench for the mounting screws
• Torque wrench
• About half an hour for an experienced mechanic

Scope of delivery

1 × ignition coil with ignition cable and spark plug connector (90-degree angle). Not included in delivery: tools, spark plug.

Frequently Asked Questions

Does this ignition coil fit my 150cc GY6 engine?
Before ordering, compare the connection type and the pin configuration with the existing part.

Does this component need to be registered?
No. This replacement/wear part does not require registration; important factors are correct dimensions, design, and proper installation.

Does this component need to be registered?
No. This replacement/wear part does not require registration; important factors are correct dimensions, design, and proper installation.