Moturo choke cable 1050mm for 150cc to 250cc ATV Quad

Moturo Choke Cable 1090mm for 150cc to 250cc ATV/Quad

The Moturo choke cable for 150cc to 250cc ATVs/Quads — a typical wear part that should be replaced after prolonged use to prevent the choke mechanism on the carburetor from jamming. 1090mm cable, 68mm sleeve, includes solder nipple, ready for installation.

The choke cable transfers the movement from the choke lever on the handlebar to the carburetor. The cable is approx. 1090mm long, the sleeve approx. 68mm — suitable for common 150cc to 250cc carburetor designs on ATVs and quads. A solder nipple is included, allowing you to shorten the cable end and solder it on after measuring it against your carburetor.

Replacement takes about half an hour with wrenches, side cutters, and a soldering iron. Before installation, trim the cable length against the original cable and clip the sleeve into the existing holder.

Choke cable for ATV and quad, made by Moturo.

Performance · Material · Specs

• Cable length approx. 1090mm, sleeve length approx. 68mm
• Includes solder nipple for adjustment to the carburetor model
• Suitable for 150cc to 250cc ATVs and quads
• Universal item — check dimensions against the original cable before ordering

Important Notes – please read

Original spare part design, no separate ABE (general operating permit) required. Universal item — compare cable length, sleeve length, and nipple fitting against the original cable of your ATV/quad before ordering.

Tools & Time Required

• Wrenches for the carburetor clamping screw
• Side cutters for cutting to length
• Soldering iron for the nipple
• Approx. half an hour for an experienced mechanic

Scope of delivery

1 × Choke cable with sleeve and solder nipple. Not included: solder, tools.

FAQ

Does this cable fit every 150cc to 250cc carburetor on ATVs and quads?
Universal item; compare cable length, sleeve length, and nipple fitting against the original cable of your ATV/quad before ordering.

Do I need a TÜV registration?
No. Original spare part design, no separate ABE required.

How do I attach the nipple to the end of the cable?
Cut the cable to the desired length, slide on the solder nipple, and solder it in place. Standard Bowden cable technology.