Moturo tie rod cpl. with 2 x tie rod ends -210mm- for 50-125cc ATV Quad

Moturo Tie Rod Set for 50-125cc ATV/Quad

The complete Moturo tie rod set for your 50 to 125 cc ATV/Quad — the steering link between the steering knuckles of your front axle. Tie rod 210 millimeters plus two tie rod ends and M10 castle nuts, ready for installation.

The tie rod measures 210 millimeters without the ball joints; with the tie rod ends, it reaches a total length of approximately 315 millimeters. The ends are attached to the steering knuckles of your front axle with M10 castle nuts.

Replacement takes about an hour using an open-end wrench set, cotter pin pliers, and a torque wrench.

Tie rod set for your ATV/Quad, made by Moturo.

Performance · Material · Specs

• Tie rod 210 millimeters without ball joints
• Total length with tie rod ends approximately 315 millimeters
• Two tie rod ends plus two M10 castle nuts included in the set
• Universal part for 50 to 125 cc ATVs and quads

Important notes – please read

Original spare part design, no separate ABE (general operating permit) required. Universal item — check length, thread, and ball joint mount against your old tie rod before ordering. Not suitable if length or thread differs.

Tools & Time Required

• Open-end wrench set in common sizes
• Cotter pin pliers for the safety pins
• Torque wrench
• About one hour for an experienced mechanic

Scope of delivery

1 × tie rod 210 millimeters, 2 × tie rod end, 2 × M10 castle nut. Not included: safety cotter pins, tools.

Frequently Asked Questions

Does the set fit every 50 to 125 cc ATV?
Universal item — compare length and thread with your old tie rod before ordering.

Do I need a TÜV registration?
No. Original spare part design in the stated dimensions.

Are safety cotter pins for the castle nuts included?
No, the cotter pins are not included in the scope of delivery.